EOS FaçadeThe EOS Facade Stud & Track are cut to lengths that you require, and are bundled to meet your programme needs. The ends of our product are unique; a swaged end gives a flush finish to ensure reduced waste on site. The EOS Facade panel is not manufactured until your site survey has been carried out, this ensures fit first time. The team create fully designed and engineered panels, manufactured off site to your requirements.
Click to see our stunning curved facade designs at Hexham Hospital, Northumberland
Click to see our expertise in educational project delivery with Middlesbrough College
|
|
Service Holes:
All Panel and Component parts can have service holes pre-punched in the factory as part of the manufacturing process. All penetrations can be placed to specific client requirements both horizontally and vertically. The size of penetration across the 65, 100 150 section is 32mm diameter. The 100 section has an added 65mm diameter punch.
NOTE: Locations in structural frames have zones in which penetrations cannot be located; these are high-lighted on a scheme by scheme basis.